Cuando presiono la tecla apropiada durante el inicio, ¿estoy ingresando al BIOS o CMOS?

Tabla de contenido:

Video: Cuando presiono la tecla apropiada durante el inicio, ¿estoy ingresando al BIOS o CMOS?

Video: Cuando presiono la tecla apropiada durante el inicio, ¿estoy ingresando al BIOS o CMOS?
Video: ¿Cómo Configurar un VPN en iPhone? 2024, Marcha
Cuando presiono la tecla apropiada durante el inicio, ¿estoy ingresando al BIOS o CMOS?
Cuando presiono la tecla apropiada durante el inicio, ¿estoy ingresando al BIOS o CMOS?
Anonim
Cuando llegue al punto en el que está aprendiendo a configurar los ajustes de inicio de su computadora, es posible que se sienta confundido acerca de BIOS y CMOS. ¿A cuál está accediendo para modificar esa configuración? La publicación de preguntas y respuestas de SuperUser de hoy tiene la respuesta a la pregunta de un lector curioso.
Cuando llegue al punto en el que está aprendiendo a configurar los ajustes de inicio de su computadora, es posible que se sienta confundido acerca de BIOS y CMOS. ¿A cuál está accediendo para modificar esa configuración? La publicación de preguntas y respuestas de SuperUser de hoy tiene la respuesta a la pregunta de un lector curioso.

La sesión de Preguntas y Respuestas de hoy nos llega por cortesía de SuperUser, una subdivisión de Stack Exchange, un grupo de sitios web de preguntas y respuestas impulsado por la comunidad.

Foto cortesía de gynti_46 (Flickr).

La pregunta

El lector Superusuario Space Ghost desea saber si está accediendo a BIOS o CMOS durante el inicio:

For the longest time I have assumed I was entering the BIOS setup and that CMOS is a chip that holds the BIOS settings I set/choose in its memory.

I recently read somewhere that when I am configuring boot order, etc. that it is actually the CMOS setup. I am a little bit confused now, could someone explain this to me?

¿Space Ghost está accediendo a la BIOS o al CMOS durante el inicio?

La respuesta

El colaborador de Superusuario Frank Thomas tiene la respuesta para nosotros:

Both. CMOS stores BIOS configuration information. When you enter setup, you are running the BIOS’s configuration program, which loads the settings defined in CMOS. You are “setting up” the CMOS by providing configuration information the BIOS will use as it runs.

The BIOS is a program written as firmware onto a ROM so that it cannot be written to (except by an all-or-nothing flash operation, which is dangerous, so not an everyday operation). The BIOS ROM stores its configuration information on the CMOS when you hit F10. That is why clearing the CMOS restores your BIOS settings to default and does not delete the BIOS itself, leaving you with an expensive paperweight.

For example, the BIOS has a subroutine that will load the operating system per the boot order. The boot order information, however, (i.e. use first CD-ROM as first device) is stored in the CMOS. If you clear the CMOS, the BIOS will use a default, usually the first disk on the first disk controller that is populated.

¿Tienes algo que añadir a la explicación? Apaga el sonido en los comentarios. ¿Quieres leer más respuestas de otros usuarios de Stack Exchange con experiencia en tecnología? Echa un vistazo a la discusión completa aquí.

Recomendado: